Nancy Endwright - Imastamping: Oh My Fright

Friday, September 25, 2026

Oh My Fright - Fun Fold Card

Aren't these little ghosts and bats adorable? They are from the Oh My Fright Bundle. I used Black Dimensionals behind the ghosts' eyes. The bats' eyes are poked out, but if not, you could add a white Gel Pen. Those little adhesive ghosts were added to the banner. See the instructions for this sweet card. I cased this card from Rosemarie Gonzalez for a Facebook group I joined last month called Creep It Crafty.

Stamp Set: Oh My Fright

Cardstock: Basic Gray, Basic White, Pumpkin Pie, Frightfully Fun DSP

Ink: Tuxedo Black Memento

Other: Stampin’ Cut & Emboss Machine, Oh My Fright Dies, Nested Essential Dies, 3/8” Iridescent Ribbon, Adhesive Backed Bats, Ghosts & Dots, Multipurpose Liquid Glue, Black Stampin’ Dimensionals, and Mini Glue Dots

1. The base of the card is Basic Gray cardstock cut at 4-1/4” x 10-1/2” and scored at 5-1/2”.

2. Cut the Frightfully Fun DSP at 4” x 4-3/4” (spooky tree). Adhere to the front of the Basic Gray card base.

3. Die-cut the large tag from the Oh My Fright Dies using Basic Gray cardstock. Score the tag at ½ from the bottom. Fold, burnish, and adhere to the bottom of the inside of the card base with adhesive.

4. Die-cut the tree and 3 bats from Basic Black cardstock. Poke out the bats’ eyes.

5. Die-cut two ghosts from Basic White cardstock. Attach Black Stampin’ Dimensionals behind the eyes.

6. Adhere the tree with dots (not a lot) of Multipurpose Glue and attach to the front of the Basic Gray tag, but do not cover the hole for the ribbon.

7. Die-cut a Pumpkin Pie cardstock banner using the Nested Essential Dies. Ink up “Happy Halloween” with Tuxedo Black Memento on the Pumpkin Pie banner and adhere Stampin’ Dimensionals to the bottom of the tag only before adhering the banner.

8. Add a ghost on the tag and one above the tag. Add two bats to the DSP with Mini Glue Dots.

9. Add ribbon to the tag through the hole or use a Mini Glue Dot. Tie a bow or faux bow. Trim off excess.

10. For the inside: Cut a 4” x 5-1/4” Basic White cardstock and adhere the 1” x 4” (swirl sheet) DSP at the bottom. Adhere to the inside of the card so that it covers the ½” of the tag.

11. Add the third bat to the inside at the top right with a Glue Dot.